Table of Contents
Advertisement
P100IH ISDN Router
Chapter 10:
Telnet Configuration and Capabilities
10.1 About Telnet Configuration
Before the Prestige is properly setup for TCP/IP, the only option for configuring it is through the console
port. Once your Prestige is configured, you can use telnet to configure it remotely as shown below.
Figure 10-1 Telnet Configuration on a TCP/IP Network
10.2 Telnet Under NAT
When NAT is enabled and an inside telnet server is specified, telnet connections from the outside will be
forwarded to the inside server. So to configure the Prestige via telnet from the outside, you must first telnet
to the inside server, and then telnet from the server to the Prestige using its inside LAN IP address. If no
insider server is specified, telnet to the SUA 's IP address will connect to the Prestige directly.
Telnet
10-1
Advertisement
Table of Contents
Troubleshooting
