Table of Contents
Advertisement
P100IH ISDN Router
You can configure your Prestige to receive calls from remote dial-in users, e.g., telecommuters, as well as
remote nodes. There are several differences between dial-in users and remote nodes, as summarized in the
table below.
Table 7-1 Remote Dial-in Users/Remote Nodes Comparison Chart
Remote Dial-in Users
Your Prestige will only answer calls from remote
dial-in users; it will not make calls to them.
All remote dial-in users share one common set of
parameters, as defined in the Default Dial In Setup
(Menu 13).
This chapter discusses how to setup default dial-in parameters for both remote node and remote dial-in
users. The following sections give two examples of how your Prestige can be configured as a dial-in server.
Dial-In Server Configuration
Dial-in Server Configuration
Remote Nodes
Your Prestige can make calls to and receive calls
from the remote node.
Each remote node can have its own set of
parameters such as Bandwidth On Demand.
Chapter 7:
7-1
Advertisement
Table of Contents
Troubleshooting
