ZyXEL Communications Prestige 100IH User Manual page 94

IP Address Supplied By:
Dial-in User
IP Pool
IP Pool: IP Start Addr
IP Count (1,2)
Session Options:
Edit Filter Sets
Once you have completed filling in Menu 13 - Default Dial-in Setup, press [Enter] at the message [Press
ENTER to Confirm...] to save your configuration, or press [Esc] at any time to cancel.
7.2.2 Default Dial-in Filter
Use Menu 13.1 – Default Dial-in Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between all dial-in users and your Prestige. Note that the filter set(s) only applies to the dial-in users
7-6
If set to Yes, the Prestige will allow a remote host to
specify its own IP address.
If set to No, the remote host must use the IP address
assigned by your Prestige from the IP pool, configured
below. This is to prevent the remote host from using an
invalid IP address and potentially disrupting the whole
network.
This field tells your Prestige to provide the remote host
with an IP address from the pool. This field is required if
Dial-In IP Address Supplied By: Dial-in User is set to
No. You can configure this field even if Dial-in User is set
to Yes, in which case your Prestige will accept the IP
address if the remote peer specifies one; otherwise, an
IP address is assigned from the pool.
This field is applicable only if you selected Yes in the
Dial-In IP Address Supplied By: IP Pool field.
The IP pool contains contiguous IP addresses and this
field specifies the first one in the pool.
In this field, enter the number (1 or 2,) of addresses in
the IP Pool. For example, if the starting address is
192.168.135.5 and the count is 2, then the pool will have
192.68.135.5 and 192.68.135.6
Press Yes, then [Enter] to edit the filter sets. Keep in
mind that the filter set(s) will only apply to remote dial-in
users but not the remote nodes.
Note that spaces and [-] symbol, are accepted in this
field. For more information on customizing your filter
sets, see Chapter 8 - Filter Configuration. The default is
blank, i.e., no filters.
P100IH ISDN Router
(Default = Yes)
Yes/No
Yes/No
(Default = No)
1, 2
Default = No
Dial-In Server Configuration