Table of Contents
Advertisement
Rem IP Address
Rem IP Subnet
Mask
My WAN Addr
NAT
Address Mapping
Set=
Metric
Private
RIP
Version=
6-4
Table 6-2 TCP/IP Remote Node Configuration
This will show the IP address you entered for this remote node
in the previous menu.
Enter the subnet mask for the remote network.
Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network
number. If this is the case, enter the IP address assigned to the WAN
port of your Prestige.
Note that this is the address assigned to your local Prestige
WAN, not the remote router. If the remote router is a Prestige,
then this entry determines the local Prestige Rem IP Address
Table 6-1
in menu 11.1 (see
Choose from None, Full Feature or SUA Only. See Chapter 4:
for a full discussion of this new feature.
A NAT Server Set is a list of LAN side servers mapped to
external ports (similar to the old SUA menu 15.1 before). You
may enter any server set number up to 10, but the first one is
used foe SUA only.
The metric represents the "cost" of transmission for routing
purposes. IP routing uses hop count as the measurement of
cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and 15.
In practice, 2 or 3 is usually a good number.
This parameter determines if the Prestige will include the route
to this remote node in its RIP broadcasts. If set to Yes, this
route is kept private and not included in RIP broadcast. If No,
the route to this remote node will be propagated to other hosts
through RIP broadcasts.
Press the space bar to select the RIP direction from Both/In
Only/Out Only.
Press the space bar to select the RIP version from RIP-1/RIP-
2B/RIP-2M.
).
Remote Node TCP/IP Configuration
P100IH ISDN Router
1 to 15
Yes/No
(Default=Both)
RIP-1
(default)
Advertisement
Table of Contents
Troubleshooting
