Power On Your Prestige; Figure 2-3 Power-On Display; Figure 2-4 Login Screen - ZyXEL Communications Prestige 100IH User Manual

2.4

Power On Your Prestige

At this point, you should have connected the console port, the ISDN BRI port, the Ethernet port and the
power port to the appropriate devices or lines. You can now apply power to the Prestige by flipping the
power switch to on (I is ON, O is OFF).
Step 1. Initial Screen
When you power on your Prestige, it performs several internal tests as well as line initialization. After the
initialization, the Prestige asks you to press Enter to continue, as shown.
Copyright (c) 1994 - 2000 ZyXEL Communications Corp.
ethernet address: 00:a0:c5:77:03:42
Resetting ISDN firmware.(2) ISDN Firmware DSS1: V 09D
...............................Press ENTER to continue...
....................
Step 2. Entering Password
The login screen appears after you press Enter, prompting you to enter the password, as shown below.
For your first login, enter the default password 1234. As you type the password, the screen displays a (X)
for each character you type.
Please note that if there is no activity for longer than 5 minutes after you log in, your Prestige will
automatically log you out and will display a blank screen. If you see a blank screen, press [Enter] to bring
up the login screen again.
2-4

Figure 2-3 Power-On Display

Enter Password : XXXX

Figure 2-4 Login Screen

P100IH ISDN Router
Hardware Installation and Setup