Remote Node Filters; Figure 9-11 Filtering Remote Node Traffic; Figure 9-12 Default Dial-In Filter - ZyXEL Communications Prestige 100IH User Manual

9.4.2

Remote Node Filters

Go to Menu 11.5 (shown below) and enter the number(s) of the filter set(s) as appropriate. You can cascade
up to four filter sets by entering their numbers separated by commas. The factory default filter set,
NetBIOS_WAN, is inserted in protocol filters field under Call Filter Sets in Menu 11.5 to block local
NetBIOS traffic from triggering calls to the remote node.
9.4.3 Default Dial-in Filter
Use
Menu 13.1 – Default Dial-in Filter to specify the filter set(s) to apply to the incoming and
outgoing traffic between all dial-in users and your Prestige. Note that these filter set(s) only apply to the
dial-in users but not the remote nodes. You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9,
12, in each filter field. The default is no filters.
9-16
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters=

Figure 9-11 Filtering Remote Node traffic

Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=

Figure 9-12 Default Dial-in Filter

P100IH ISDN Router
Factory Default Filter
Filter Configuration