Table of Contents
Advertisement
Clearing Memory
Before you use your ER-260EJ ECR for the first time, you must perform a memory all
clear to insure that all totals and counters are cleared and that the default program is
installed.
CAUTION: The p rocedures described in this area are security sensitive. Clearing
the ER-260EJ memory after the register is put into service will erase all
programming as well as totals and counters. Do not share this information with
unauthorized users and distribute the "SERVICE MODE" only to those you may
want to perform these functions.
1. Move to the SERVICE MODE.
2. Turn the power switch located on the right side of the register to the OFF position.
3. Press and hold the key position where the SUBTOTAL key is located on the
4. Continue to hold the appropriate key while turning the power switch to the ON
5. Press the upper left key of the keyboard, then the lower left key, then the upper
6. The SERVICE MODE menu displays. The RAM Clear procedure is complete and
SAM4S ER-260EJ Manual
default keyboard layout.
position. The message "RAM ALL CLEAR" displays.
right key, and finally press the lower right key.
1
2
the receipt prints.
3
SUB
TOTAL
4
Getting Started • 25
Advertisement
Table of Contents
