Clearing Memory - Sam4s ER-230JB Operating And Programming Manual

Clearing Memory

Before you use your ER-230EJ ECR for the first time, you must perform a memory all
clear to insure that all totals and counters are cleared and that the default program is
installed.
CAUTION: The procedures described in this area are security sensitive. Clearing the
ER-230EJ memory after the register is put into service will erase all programming as
well as totals and counters. Do not share this information with unauthorized users
and distribute the "SERVICE MODE" only to those you may want to perform these
functions.
1. Move to the SERVICE MODE.
2. Turn the power switch located on the right side of the register to the OFF position.
3. Press and hold the key position where the CHEQUE key is located on the default
4. Continue to hold the appropriate key while turning the power switch to the ON
5. Press the upper left key of the keyboard, then the lower left key, then the upper
6. The SERVICE MODE menu displays. The RAM Clear procedure is complete and
7. If you want to allocate memory by default value, Press CASH key only.
Or follow the On-screen prompts.
SAM4S ER-230EJ Manual
keyboard layout.
position. The message "RAM ALL CLEAR" displays.
right key, and finally press the lower right key.
1
2
the receipt prints.
LOAD DEFAULT SET
N=X/TIME Y=CASH
PLU #
1000
3
CHEQUE
4
Getting Started • 25