Skewed Print Check - Lexmark MS315 Service Manual

Actions
Step 4
Check the following fuser components for wear or damage:
•
Gears
•
Exit rollers
•
Belt fuser
Are they free of damage?
Step 5
a
Turn off the printer.
b
Remove the rear door and cover.
c
Disconnect the fuser cable connected to PCN5 of the power supply.
d
Check for approximate correct resistance on the fuser cable:
•
220 V fuser—43 ohms
•
110 V fuser—10 ohms
•
100 V fuser—8 ohms
Is the resistance equal to any of the above values?

Skewed print check

Actions
Step 1
a
POR into the Diagnostics menu and perform a print test:
Diagnostics Menu > Print Tests > Tray 1
b
Adjust the margins if necessary:
Diagnostics Menu > Registration
Does the error remain?
Step 2
Does the skew appear every two pages?
Step 3
Check the media source.
Is the media from Tray 1?
Yes
Go to step 5.
The problem is solved. Replace the fuser. See
Yes
Go to step 2.
Go to step 9.
Go to step 4.
Diagnostic information
36
4514
No
Replace the fuser. See
"Fuser removal" on
page 238.
"Fuser removal" on
page 238.
No
The problem is solved.
Go to step 3.
If the media is from the
MPF, then go to step 6.