Too Many Trays Attached [58]; Unformatted Flash Detected [53]; Unsupported Option In Slot [X] [55]; Weblink Server Not Set Up. Contact System Administrator - Lexmark MS315 Service Manual

Too many trays attached [58]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Unformatted flash detected [53]

Try one or more of the following:
• From the printer control panel, press
•
Format the flash memory device.
Note: If the error message remains, then the flash memory device may be defective and need to be replaced.

Unsupported option in slot [x] [55]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Weblink server not set up. Contact system administrator.

From the printer control panel, press
Note: If the message appears again, then contact your system support person.
User attendance messages (0–99.99)
User attendance messages (0‑99.99)
Error code Description
31.21 Capactive Toner Level Sensing (CTLS) reading out of
range.
31.22 Excessive CTLS noise.
31.23 Abrupt change detected in CTLS reading.
31.25 CTLS calibration capacitor reading is too low
to stop the defragmentation and continue printing.
to clear the message.
Action
Go to
Go to
Go to
Go to
Diagnostic information
77
"CTLS service check" on page
"CTLS service check" on page
"CTLS service check" on page
"CTLS service check" on page
4514
91.
91.
91.
91.