Entering Recovery mode
This mode will allow the printer to boot from a secondary set of instructions to allow a code flash to the printer. Code
can be flashed from a PC by USB.
1
Turn off the printer.
2
Press and hold 7, 2, and 8 simultaneously.
3
Turn on the printer.
4
Release the buttons after 10 seconds.
Accessing the Network SE menu
This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1
Navigate to:
Networks/Ports > Standard Network > Standard Network Setup.
2
Press and hold 6, 7, and 9 simultaneously.
Service engineer menu
Accessing the service engineer (SE) menu
From a Web browser on a host PC, add /se to the printer IP address.
Service engineer (SE) menu
This menu should be used as directed by the next level of support.
Top level menu
Print SE Menus
General
Code Revision Info
History
MAC
Intermediate menu
Copyright — Displays copyright information
•
Network code level — Displays network code level
•
Network Compile Info — Displays network compile information
•
Printer Code Level — Displays printer code information
•
Printer Compile Info — Displays compile information
•
Print History
•
Mark History
•
History Mode
•
Set Card Speed
•
LAA
•
Keep Alive
Service menus
140
4514