Lexmark MS315 Service Manual page 54

Error code Description
202.36 Long paper or shingled multi feed stopped before
sending to duplex.
202.43 During warm up flush, media that passed the input
sensor failed to reach the exit sensor.
202.45 During warm up flush, sheet detected too long over
exit sensor.
Sensor (fuser exit) jam service check
Action
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Step 2
Check the fuser exit sensor cable JEXIT1 for proper connection.
Is it properly connected?
Step 3
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Exit
Does the sensor state on the control panel display change when it is
toggled?
Step 4
Check the fuser gears and rollers for damage.
Are they free of damage?
Step 5
Does the error remain?
Action
Go to "Duplex service check" on page
Go to "Sensor (fuser exit) jam service check" on
page 54.
Go to "Sensor (fuser exit) jam service check" on
page 54.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
Contact the next level
of support.
Diagnostic information
54
4514
57.
No
Clear the paper path of
any media fragments.
Reseat the cable.
Replace the fuser. See
"Fuser removal" on
page 238.
Replace the fuser. See
"Fuser removal" on
page 238.
The problem is solved.