Laser scanning unit (LSU) removal
1
Remove the right cover. See
2
Remove the left cover. See
3
Remove the rear door and cover. See
4
Remove the top cover. See
5
Remove the cooling fan. See
6
Disconnect the cable JGLV1 or J6 from the controller board.
7
Disconnect the cable (A) from the LSU.
8
Before loosening the screws securing the LSU, use a sharp pencil or a small, flat-blade screwdriver to mark the
location of the LSU on the printer frame. This will be helpful in positioning the new LSU.
"Right cover removal" on page
"Left cover removal" on page
"Rear door and cover removal" on page
"Top cover removal" on page
"Cooling fan removal" on page
Repair information
240
185.
168.
232.
239.
186.
4514