Table of Contents
Advertisement
Once you have completed setting the Solar Siren, refit
the DIP switch cover and replace the three cover fixing
screws. Do not over tighten the screw as this could
damage the thread.
Initial Power-Up of the Solar Siren
1. Connect the 9V PP3 initial power battery to the
battery clip.
Connect the rechargeable battery to the charging
leads. Connect the Red lead to the Red (+) terminal
and the Black lead to the Black (-) terminals.
Note: Once the batteries have been connected, the
Siren will be operational and it is important that the
Solar panel receives sufficient light to maintain the
battery charge. The Siren should not be operated
repeatedly during installation and testing, as this will
rapidly drain the battery. It is recommended that
the Siren be left for at least a day in order to charge
the battery before the system is armed.
2. Press the anti-tamper switch, the LEDs will flash
together to indicate that the unit is operational.
3. Hinge the front cover locating tabs over the top
edge of the back plate and carefully push the base
of the siren cover into place. Secure the siren
cover in place by refitting the fixing screw in the
bottom edge of the cover. Do not over tighten the
screw as this could damage the thread.
Important: Ensure that the rear tamper switch is
closed when you fit the siren cover to the back plate
(i.e. listen for the switch to click). If the switch does
not close this will prevent the Solar Siren from
operating correctly.
4. The fitting of the Solar Siren is now complete.
Siren Service Mode
In order to remove the Siren from the wall to change
the batteries, it is necessary to place the Siren into
Service Mode to prevent the Tamper protection
switch on the Siren operating and triggering an alarm.
The Siren can be switched into Service Mode using
either the Remote Control or the Remote Keypad as
follows:
Remote Control:
Press and hold the
Remote Keypad:
Enter your User ccess Code, then press and hold
the Disarm button for 6 seconds.
?
?
?
User Access Code
The Siren will produce 2 short beeps as the Disarm
button is pressed followed by a single long beep 6
seconds later to indicate it has switched into
Service Mode.
Siren Operating Mode
When you have completed any alterations to the
system remember to switch the Siren into
Operating Mode.
The Siren can be switched into Operating Mode
using either the Remote Control or Remote Keypad
as follows:
Remote Control:
Press and hold the
Remote Keypad:
Enter your User ccess Code, then press and hold
the rm button for 6 seconds.
?
?
?
User Access Code
fter 6 seconds the Siren will produce a single long
beep to indicate that it has switched into Operating
Mode in a Disarmed state. The rm button should
be released during or immediately after the long
beep, otherwise the system will rm.
17
button for 6 seconds.
?
,
button for 6 seconds.
?
,
Hide quick links:
Advertisement
Table of Contents
