Compaq AlphaServer GS60E Service Manual page 55

Example 3–4 Sample Test Command, System Test (Continued)
Shutting down drivers...
Shutting down units on tulip2, slot 12, bus 0, hose 4...
Shutting down units on floppy1, slot 0, bus 1, hose 4...
Shutting down units on isp4, slot 6, bus 0, hose 4...
Shutting down units on isp5, slot 7, bus 0, hose 4...
Shutting down units on isp6, slot 8, bus 0, hose 4...
Shutting down units on isp7, slot 9, bus 0, hose 4...
Shutting down units on isp8, slot 10, bus 0, hose 4...
Shutting down units on tulip3, slot 11, bus 0, hose 4...
Shutting down units on tulip0, slot 12, bus 0, hose 0...
Shutting down units on floppy0, slot 0, bus 1, hose 0...
Shutting down units on isp0, slot 4, bus 0, hose 0...
Shutting down units on isp1, slot 6, bus 0, hose 0...
Shutting down units on isp2, slot 7, bus 0, hose 0...
Shutting down units on isp3, slot 8, bus 0, hose 0...
Shutting down units on tulip1, slot 11, bus 0, hose 0...
:
:
›
P00>>>
–
In Example 3-4, the operator enters the test command. The
complete test suite runs for 1200 seconds.
—
To stop execution of the test command before normal completion,
use Ctrl/C (^C). Termination using ^C may take a number of
seconds depending upon the particular configuration being tested.
˜
Memory testing is done separately. Status messages indicate the
start of the console-based exercisers.
™
Testing is complete.
š
All exercisers are stopped, as indicated by the status messages.
›
The console prompt returns.
Console Display and Diagnostics 3-9