Compaq AlphaServer GS60E Service Manual page 129

Removal
1. Shut down the operating system and turn the keyswitch to Off.
2. Ground yourself to the cabinet with an antistatic wrist strap.
3. Note the locations of the modules in the card cage and remove the modules.
See Section 5.1.
4. At the front of the card cage, use the 8-mm nutdriver to remove the kepnuts
from the terminal cover (see
10-mm nutdriver, remove the nuts and washers that attach the power and
ground cables to the power posts. Save the nuts and washers.
5. Disconnect the CCL cable. See
6. At the front of the cabinet, use the Phillips head screwdriver to remove the
top and bottom brackets from the card cage and frame (see
brackets and screws.
7. At the rear of the cabinet, remove the side and bottom brackets from the
frame and from the card cage (see
CAUTION: The following step requires two people. Because of the height of
the card cage in the cabinet, you should not remove this assembly by yourself.
8. Slide the card cage assembly out the front of the cabinet.
™
in Figure 5-6). Save the kepnuts. Using the
š
.
œ
). Save the brackets and screws.
Removal and Replacement Procedures
›
). Save the
5-21