Compaq AlphaServer GS60E Service Manual page 115

6. Build the EEPROM. See
7. Power down the system, replace the other processor modules (see Section
5.1.4), and power up the system.
8. Copy the EEPROM environment variables from a secondary processor to the
new primary processor. To do this, set a different module as primary and
copy the environment variables using the build –c command. See
9. Set processor 0 as the primary processor. Then enter into the EEPROM the
8-digit LARS number and a short message (68 characters maximum) stating
the date and reason for service. See
10. Boot the operating system.
›
.
ž
.
Removal and Replacement Procedures

.
5-7