Compaq AlphaServer GS60E Service Manual page 149

Removal
1. Lift off the system cabinet cover and set aside (see
2. Open the system cabinet's front and rear doors
3. Remove the front and rear screws holding the right panel
4. Pull the bottom of the panel away from the cabinet, lift up, and remove
Repeat steps 3 and 4 on the left side to remove the left system cabinet panel.
5. To remove the front door, open it and unplug the signal cable from the rear
of the OCP, located at the top inside of the front door. Unscrew the top
bracket securing the door to the cabinet. Lift the door off the bottom hinge
pin and set aside.
6. To remove the rear door, open it and unscrew the top bracket securing the
door to the cabinet. Lift the door off the bottom hinge pin and set aside.
Replacement
•
Reverse the steps in the Removal procedure.
—
.
Removal and Replacement Procedures
–
, Figure 5-15).
˜
.
™
5-41
.