Compaq AlphaServer GS60E Service Manual page 174

Table B–2 Environment Variables (Continued)
Variable Attribute
boot_reset Non-
volatile
console Non-
volatile
Volatile
cpu
cpu_enabled Non-
volatile
cpu_primary Non-
volatile
Volatile
d_harderr
d_report Volatile
d_softerr Volatile
Non-
dump_dev
volatile
B-6 Service Manual
Function
Resets system and displays self-test results during
booting. Default value is off.
The type of terminal being used for the console,
either serial (default) for a standard video
terminal or graphics for a graphics display. If
the terminal is a graphics display, the system
must have a PCI with a standard I/O module and
a TGA graphics controller. If that hardware is not
available, the variable remains set to serial.
Selects the current boot processor.
A bitmask indicating which processors are enabled
to run (leave console mode). Default is 0xffff.
A bitmask indicating which processors are enabled
to become the next boot processor, following the
next reset. Default is 0xffff.
Determines action taken following a hard error.
Values are halt (default) and continue. Applies
only when using the test command.
Determines level of information provided by the
diagnostic reports. Values are summary and full
(default). Applies only when using the test
command.
Determines action taken following a soft error.
Values are continue (default) and halt. Applies
only when using the test command
Device to which dump file is written if system
crashes, if supported by the operating system.