Compaq AlphaServer GS60E Service Manual page 131

4. At the rear of the cabinet, use the Phillips head screwdriver to loosely
install the reserved side bracket to the frame with two reserved screws.
Line up the other two holes in the bracket with the card cage holes and
insert two reserved screws. Tighten all four screws. Attach the card cage to
the frame at the bottom with the reserved screws.
5. At the front of the cabinet, use the Phillips head screwdriver to attach the
card cage to the frame at the top and bottom with five reserved screws.
6. Install all the modules in the card cage.
7. Attach the CCL cable.
8. Use the 10-mm nutdriver and the reserved nuts to attach the power and
ground cables to the power posts. (Place a washer behind the power cable
connector and one in front of the connector, then attach and tighten the
nut.) The yellow cable (+48 V) attaches to the top post; the gray cable
(ground) attaches to the bottom post.
9. Use the 8-mm nutdriver and the reserved kepnuts to install the terminal
cover over the power posts.
Verification
Power up the system and check that all the modules appear in the self-test
display. Enter the show configuration, show device, and test commands.
Removal and Replacement Procedures 5-23