Compaq AlphaServer GS60E Service Manual page 127

I/O Hose Cable Removal
1. Shut down the operating system and power down the system.
2. Ground yourself to the cabinet with an antistatic wrist strap.
3. Loosen the captive screws (slotted) to remove the cable connectors at both
ends of the I/O cable to be replaced. See
I/O Hose Cable Replacement
1. Attach the TLSB end with pin 50 on top. Torque the screws to 6 inch-
pounds/
2. Route the replacement I/O cable through the same path as the original one
was routed.
3. Attach the I/O bus end. The connector is asymmetrical to ensure proper
orientation.
Verification
Power up the system, check that the green LED near the top connector lights,
and check that the console display includes the I/O bus connected to this cable.
˜
in Figure 5-5.
Removal and Replacement Procedures 5-19