Compaq AlphaServer GS60E Service Manual page 130

Replacement
1. Ground yourself to the cabinet with an antistatic wrist strap.
CAUTION: The following step requires two people. Because of the height of
the card cage in the cabinet, you should not install this assembly by yourself.
2. From the front, slide the replacement card cage into the cabinet so that the
label is at the top on the front and the power filter is to the left.
3. Attach the reserved front top and bottom brackets and the rear bottom
bracket to the card cage using the reserved flathead screws.
NOTE: The rear bottom bracket is deeper than the front one. If these two
brackets are swapped, the holes in the side bracket will not line up correctly
in the next step.
5-22 Service Manual
Continued on next page