Automatically Feeding Envelopes (DM400c)
1. Load envelopes
into the feeder face
up with their top
edges against the
registration wall.
2. Slide the side
guide up to the
envelopes. Allow
clearance so that
envelope feed is not
restricted.
3. Select seal or no-
seal using the
Seal/No Seal Lever.
4. Press Start. The system automatically feeds the envelopes,
prints the digital meter stamp and ejects the envelope.
IMPORTANT: Always ensure that your prints are clear
and complete. Poor prints may be rejected by your Postal
Authority. If you notice missing lines in the print as shown
in the illustration, perform a printhead purge as described
on page 7-14 of this guide.
The indicia above is a black and white representation
of the approved Red indicia. Only Red approved ink
should be used in the machine.
SDC755A
3 • Running Mail
Seal/ No Seal Lever
Side Guide
Start
button
3-11