Removing The Shield And Wick - Pitney Bowes DM300c series Operator's Manual

7 • Maintenance

Removing the Shield and Wick

1. Remove the moistener
as described on page
7-10.
2. Pull up and remove
the shield and wick
from the moistener
tank.
3. Separate wick from
the shield. Clean the
wick in plain water,
and rinse thoroughly.
4. Place the wick back into the shield.
5. Reinstall the wick and holder assembly into the moistener.
6. Reinstall the moistener. Push down on the blue release lever on
the moistener.
7. Separate wick from the shield. Clean the wick in plain water, and
rinse thoroughly.
Reinstall the Moistener Tank
1. Line up the yellow tab with the yellow slot.
2. Slide the moistener tank into position on the mailing machine
base until the release lever snaps into position. See the figure at
right.
3. Resume operation.
7-12
Shield
Wick
Release
Lever
SDC755A