Konica Minolta bizhub 43 Service Manual page 99

At the end of the transfert, this window appears:
The software provides values in the 2nd column.
• Click on Calculate for lines X ADF and Y ADF.
• If the new values agree, click Write to validate the proposed settings.
After writing, the new values are sent to the scanner and the new values appears in the first column.
• When settings are finished, click on Exit Initial Set Up.
• Click on Exit to exit the software.
• Check the new settings.
Remark(s): the screenshot can change slightly, because they depends on the Makalu_210 software
version.
- 19 - MG 3000329394 - 03