Konica Minolta bizhub 43 Service Manual page 124

D12
OBJECT:ADF
- Unscew a little bit the scew A and B.
- Push the motor in direction showed by the red arrow and screw B.
- Unscrew the tension motor frame assy (torx 10).
- Remove the tension motor frame from the ADF module.
- Place the belt on the "Gear pulley 19-45-75T".
- Assembly the tension motor frame assy and place the belt on the motor gear.
- Fix the "Tension motor frame assy" on the gear frame with three "Silent bloc Screws".
- Unscrew a little bit the screw A.
- Unscrew the screw B until the belt is set.
- Screw on the screw B and then the screw A.
Caution - Don't forget to block the motor position. The lack of this step can damage the belt quickly.
• ADF feeder cover
- Unscrew the five screws holding the ADF feeder cover.
- 44 -
MODULE UNIT
( )
CONTINUED
, ADF
FEEDER COVER AND
MG 3000329394 - 03
ADF
MOTOR