Konica Minolta bizhub 43 Service Manual page 91

1.9 D
OWNLOAD SOFTWARE INTO THE FRONT PANEL BOARD
Aim of this chapter is to describe how to download software into PIC16F946 (Z1).
It must be done only if new version is diffused.
This component allows to manages touch panel, key matrix and leds of Front panel board and keypad
board.
1.9.1 M
ATERIAL
Material required is :
• 1 x MPLAB ICD 2 module (In-circuit debugger - Microchip tool),
• 1 x USB device cable,
• 1 x cable RJ11 P3 on the front panel board,
• 1 x MPLAB USB Driver.
1.9.2 I
NSTALLATION
• Install USB driver / MPLAB Application through CD-ROM.
• Connect ICD2 module to the PC through USB cable.
• Connect ICD2 module to P3 connector on the front panel board (RJ11 cable).
• Power on the front panel through UC (front panel cable).
- 11 - MG 3000329394 - 03
( )
PIC