Konica Minolta bizhub 43 Service Manual page 93

1.9.4 B
INARY IMPORT
Under MPLAB, import the file *.cof
File → Import
1.9.5 P
IC PROGRAMMATION
This step allows loading a FW into
• Click Programmer → Program
• Wait the end of the sequence
Click Programmer → Release from Reset
•
• Choose MPLAB ICD2
• Close the debugger
1.10 R
EPLACING THE SCANNER
Carry out the following procedure:
• Carry out a remote readout (if the function is enabled), see chapter 6, in the Installation guide.
• Back up the directory and the parameters via Web site, see chapter 7, in the Installation guide.
• Replace the scanner.
• Restore the directory and parameters via Web site.
• Carry out a remote readout (if the function is enabled).
- 13 - MG 3000329394 - 03