Enabling Interface Card Configuration - SATO DR308e Operator's Manual

Section 3: Operation and Configuration
3.7 INTERFACE MODE (cont'd)

3.7.1 Enabling Interface Card Configuration

INTERFACE SET is first displayed after entering to interface mode. Press FEED button if you wish to
configure the connected interface card.
The next display shows the connected interface card to be configured. Refer to the following flowcharts of the
all setting and LCD display menus available for LAN, IEEE1284 and RS-232C.
If USB interface card is connected, no selection is available.
If not, press LINE button, the next display lets you enable the optional keypad if connected.
Setting of LAN and IEEE1284
LAN setting mode
FEED
FEED
BOARD
LCD
FEED
LINE
FEED
LINE
FEED
LINE
FEED
LINE
FEED
LINE
LAN
Setting completed.
KEYPAD PORT
is displayed.
Page 3-12
FEED
FEED
FEED
FEED
When STATUS4
is selected
FEED
After setting, re-start the printer by turning
the POWER off and then on.
IEEE1284
2
setting mode
FEED
FEED
LINE
MULTI
IEEE 1284
Setting completed.
KEYPAD PORT
is displayed.
2
Return to INTERFACE SET mode.
Press FEED button while pressing
LINE button to return to previous
display.
Optional route.
FEED
1ITEM
FEED
LINE
DR308e Operator's Manual
FEED