SATO DR308e Operator's Manual page 23

2.7 CONNECTIONS (cont'd)
2.7.3 Instruction to attach the ferrite cores to the power cable
Open the two supplied ferrite cores, wrap them to the both end of the power cable and attach them as shown
below. Make sure to squeeze the ferrite core until it clicks.
* The shape of the power plug may varied depending on the location of purchased.
2.7.4 Connecting the Power Cable
Warning
• Be sure to connect the ground wire. Failure to do so may cause an electric shock.
• Do not operate the power switch or insert/remove the power cable while your hands are wet. Doing
so may cause an electric shock.
Caution
The power cable provided with this printer is for use with this printer only. It cannot be used with other
electrical devices.
1.
Connect the power cable to the AC IN power terminal on
the rear panel of the printer.
Make sure that the connector is correctly oriented.
Secure the printer with one hand, and insert the connec-
tor firmly.
2.
Insert the power plug into a AC power outlet.
A 3-pin plug is attached to the power cord provided with
your printer. One of these pins is the ground wire.
If the power outlet that you plan to use is a 3-pin type,
simply insert the power plug as is.
DR308e Operator's Manual
Power outlet end
Printer end
Section 2: Installation
Page 2-11