SATO DR308e Operator's Manual page 11

1.2 PARTS IDENTIFICATION (cont'd)
15 Supplied yellow
screwdriver
16 Roll media supply spindle
17 Roll media guide
18 Ribbon supply spindle
19 Ribbon take-up spindle
20 Head lock lever
21 Print head
22 Platen roller
23 Pitch sensor
24 Pitch sensor guide
25 Media guide shaft
15 Supplied yellow screwdriver
Used to adjust the potentiometers and Dip
switches.
Roll media supply spindle
16
Used to load the roll media, tag or label.
Roll media guide
17
Set to meet the size of the media used.
18 Ribbon supply spindle
Used to load the ribbon.
19 Ribbon take-up spindle
Used to wind up the used ribbon.
20
Head lock lever
Used to open and close the print head.
DR308e Operator's Manual
Side View of DR308e with main cover open
21
Print head
This component is used to print on the paper.
Perform maintenance at regular intervals.
22
Platen roller
This roller feeds the paper. Perform
maintenance at regular intervals.
23
Pitch sensor
Detects the holes in the tag stock so that the
media can be cut off by the cutter.
24
Pitch sensor guide
Adjustment slide used to align the position of
the pitch sensor with the holes.
25
Media guide shaft
Set to meet the size of the media used.
Section 1: Introduction
Page 1-5