SATO DR308e Operator's Manual page 18

Section 2: Installation
2.3 LOADING LABELS OR TAGS (cont'd)
6.
Attached a supplied extension guide plate to the side
of the roll media supply spindle. Attached the other
two extension guide plate to the roll media guide.
7.
Insert the supplied core adaptor to the roll media
supply spindle. Align the screw hole of the core adap-
tor with the specific screw hole on the supply spindle
according to the width of media used as stated in the
table below.
Core adaptor attachment
position
Attachment hole 1
Attachment hole 2
Attachment hole 3
8.
Fasten the core adaptor in place with the supplied
screw.
9.
Load the media.
Follow the instructions of Section 2.3.1 Loading Roll
media with small media core from step 3 onwards.
Caution
• When replacing media, bear in mind that the print
head and its surrounding area remain hot. Keep your
fingers away from these areas to prevent injury.
• Avoid touching even the edge of the print head with
your bare hands.
Page 2-6
Media width
Up to 50 mm (2in.)
50 mm (2in.)to 80 mm (3in.)
Not used
3
2
Core
adaptor
Roll
media
supply
spindle
DR308e Operator's Manual
1