SATO DR308e Operator's Manual page 49

3.10 TEST PRINT MODE (cont'd)
3.10.1 Choosing the Test Print Contents
The seven selection in this mode are as follows:
Test Print Selection
CONFIGURATION
BARCODE
HEAD CHECK
HEAD CHK SENSOR
MEMORY
FONT
FACTORY
1.
Press the LINE button to choose any option to set the test print contents.
2.
Press the FEED button to confirm your selection and proceed to the next setting.
If Configuration, Barcode, Head Check, Head Chk Sensor or Factory is selected, the printer will enter to
the TEST SIZE setting mode.
If Font or Memory is selected, the printer will enter to the Test Print Start mode.
3.10.2 Setting Test Print Size for Configuration, Barcode, Head Check and Head Chk Sensor
If you chose test prints of Configuration, Barcode, Head Check or Head
Chk Sensor in the previous menu, this screen lets you choose the width of
the test print from "03" to "08" cm, in increments of 1 cm.
1.
When TEST SIZE is displayed, press FEED button to enter to the set-
ting mode.
2.
Press the LINE button to choose the print size.
3.
Press the FEED button to confirm the setting and proceed to the next
screen.
3.10.3 Setting the Size of the Factory Test Print
For Factory test prints, this screen appears instead of the previous screen
for setting print size. In this screen, you can choose only to print the test
results in LARGE or SMALL print widths. The LARGE setting results in a
10 cm print width. The SMALL setting results in a 4 cm print width.
Caution
If you are using narrow labels, do NOT set this option to LARGE;
otherwise, this may damage the print head.
1.
When TEST SIZE is displayed, press FEED button to enter to the set-
ting mode.
2.
Press the LINE button to choose LARGE or SMALL.
3.
Press the FEED button to confirm the setting and proceed to the next
screen.
DR308e Operator's Manual
Description of print contents
The configuration settings of the printer will be printed.
The barcodes installed in this printer will be printed.
The head check pattern of the selected media size area will be printed.
The head check pattern and the sensor rating will be printed.
The contents of the memory in this printer will be printed.
The contents of the fonts installed in this printer will be printed.
The factory test print will be performed.
Section 3: Operation and Configuration
Page 3-25