SATO DR308e Operator's Manual page 47

3.9 HEX DUMP MODE (cont'd)
3.9.1 Selecting Data To Dump
Here you can choose to dump either incoming data (ONLINE) or print data
already stored in the buffer (BUFFER).
1.
When SELECT DUMP DATA is displayed, press FEED button to enter
to the setting mode.
2.
Press the LINE button to choose ONLINE or BUFFER. The default
setting is ONLINE.
3.
Press the FEED button to confirm your selection and proceed to
OFFLINE mode for getting ready to Dump Print.
Note:
When BUFFER is selected, the printer will not proceed to the next screen
if there is no data received.
3.9.2 Controlling the Hex Dump Mode
The printer will enter OFFLINE mode after Dump Data was set.
When ONLINE was set for Dump data, press LINE button to enter to
+ONLINE mode and proceed the Dump print which received data from the
host computer. During the Dump print, the number of labels printed will be
shown. During printing, press LINE button to pause the print. Press again
to resume printing. When printing is done, press the LINE button to take
the printer OFFLINE.
When BUFFER was set for Dump data, press LINE button to start the
Dump print of the buffered data. The printer goes ONLINE automatically
after the printing.
DR308e Operator's Manual
Section 3: Operation and Configuration
Page 3-23