SATO DR308e Operator's Manual page 65

MEDIA
(Be sure to use media manufactured or certified by SATO)
Size
Type
Roll Diameter
Core Diameter
Thickness
Wind Direction
RIBBON
(Be sure to use ribbon manufactured or certified by SATO)
Width
Length
Wind Direction
Winding Method
DR308e Operator's Manual
Standard Tag
Label
Tear-off/ Label
Dispenser
Cutter Tag
Label
Direct Thermal/ Thermal Transfer
Maximum outer diameter: 250 mm (9.8 in.)
Inner core diameter: 38 mm(1.5 in.) and 100 mm (4 in.),
Tag: 0.16 to 0.28 mm (0.006 to 0.011 in.)
Label: 0.07 to 0.265 mm (0.003 to 0.01 in.)
[Label using with dispenser: 0.135 - 0.265 mm (0.005 to 0.01 in.)]
Max. 300 m (984.3 ft.) (Depending on ribbon type)
Section 6: Gerneral Specifications
Width: 32 to 80 mm (1.3 to 3.1 in.)
Pitch: 25 to 181 mm (1 to 7.1 in.)
Width: 29 to 77 mm (1.1 to 3 in.)
Width including liner: 32 to 80 mm (1.3 to 3.1 in.)
Pitch: 16 to 178 mm (0.6 to 7 in.)
Pitch including liner: 19 to 181 mm (0.7 to 7.1 in.)
Width: 29 to 77 mm (1.1 to 3 in.)
Width including liner: 32 to 80 mm (1.3 to 3.1 in.)
Pitch: 22 to 178 mm (0.9 to 7 in.)
Pitch including liner: 25 to 181 mm (1 to 7.1 in.)
Width: 32 to 80 mm (1.3 to 3.1 in.)
Pitch: 25 to 181 mm (1 to 7.1 in.)
Width: 29 to 77 mm (1.1 to 3 in.)
Width including liner: 32 to 80 mm (1.3 to 3.1 in.)
Pitch: 22 to 178 mm (0.9 to 7 in.)
Pitch including liner: 25 to 181 mm (1 to 7.1 in.)
* The size may be limited by use conditions.
Roll stock
depending on media type
Face In
Max. 84mm (3.3 in.)
Face In
Paper core
Page 6-3