2.3 LOADING LABELS OR TAGS (cont'd)
2.3.2 Loading Roll media with a large media core
1.
With the power supply is off, lift up the main cover.
Make sure that the cover rests firmly so that it will not fall
forward and injure your hands.
2.
Remove the roll media guide by pressing the release
tab with your thumb and index finger and pulling it out.
3.
Unfasten the screw holding the roll media supply spin-
dle. Use a flat-blade screwdriver to unfasten the screw.
4.
Rotate the spindle to 90 degree in the upper right (coun-
ter clockwise) direction.
5.
Fasten the screw that you unfastened in step
DR308e Operator's Manual
Main cover
Roll media
guide
3
.
Section 2: Installation
Page 2-5