3.1 OPERATION PANEL (cont'd)
•
J-HOLE potentiometer
This potentiometer is used to adjust the sensing level for the jump hole sensor.
•
IM potentiometer
This potentiometer is used to adjust the sensing level of the I-mark sensor.
•
GAP potentiometer
This potentiometer is used to adjust the sensing level for the gap sensor.
•
DSW Dip switch
These switches are to set the printer to different modes when servicing. This is only used by Sato
certified servicing personnel.
•
PITCH potentiometer
This potentiometer adjusts the beginning print position in correspond to the adjustment value displayed in
the OFFSET VOLUME menu (User Mode).
•
OFFSET potentiometer
This potentiometer adjusts the option (Cutter, Dispenser, Tear-off) stop position in correspond to the
adjustment value displayed in the OFFSET VOLUME menu (User Mode).
•
PRINT potentiometer
This potentiometer adjusts the print darkness in correspond to the adjustment value displayed in the OFF-
SET VOLUME menu (User Mode).
3.2 OPERATING MODES
The operating status of this printer can be set within one of the following modes:
1.
Normal mode (including Online/Offline modes)
2.
Printer Setting mode:
•
Paper mode
•
User mode
•
Interface mode
•
Advanced Mode
•
Hex Dump mode
3.
Test Print mode
4.
Default Setting mode
The various modes are accessed by pressing the LINE button, FEED button and LCD screen while the printer
is Off, On or with certain printer settings in force.
DR308e Operator's Manual
Section 3: Operation and Configuration
Page 3-3