SATO DR308e Operator's Manual page 41

3.8 ADVANCE MODE (cont'd)
3.8.1 Selecting the Print Density
This first setting in ADVANCED MODE lets you set how dark the print quality is.
1.
When the DARKNESS RANGE is displayed, press FEED button to enter to
the setting mode.
2.
To adjust the print density, use the LINE button to select an option.
Available options are from 'A' to 'F', with 'F' being the darkest density. Only
supported range is displayed. The default value is 'A'. Adjustment of this
setting is usually unnecessary.
3.
Press FEED button to confirm your selection and proceed to the next
setting.
3.8.2 Setting the Automatic Detection of Optional Units
The next setting, PRINTER TYPE, determines whether the printer
automatically detects the installation of optional peripherals such as a
dispenser or cutter. If detected, an optional peripheral will be used without
needing further user configuration.
1.
Press FEED button to enter to the AUTO SET mode.
2.
Use the LINE button to select either YES or NO. The default option is YES
(auto detect). Choose NO if optional devices are installed, but you have
wish to override the automatic settings.
3.
Press FEED button to confirm your selection and proceed to the next
setting.
3.8.3 Choosing Print mode Option
1.
When the PRINT MODE is displayed, press FEED button to enter the print
mode setting. With this setting, you can choose between CONTINU (Con-
tinuous paper feed) or TEAROFF motion mode. If a dispenser or cutter unit
has been installed correctly, you will also see the DISPENS (Dispenser)
and CUTTER settings.
2.
Press the LINE button to select any one of the options. The default setting
is CONTINU.
3.
Press the FEED button to confirm your selection and proceed to the next
setting.
3.8.4 Backfeed Operation Settings
The printer can be set to apply or not apply a backfeed to the media before or after printing each media.
1.
When BACKFEED MOTION is displayed, press FEED button to enter to
the setting mode. BACKFEED MOTION selection only available when Cut-
ter or Dispenser is selected as in PRINT MODE.
2.
Press the LINE button to choose from AFTER, AFTER2, BEFORE or
NONE. The default setting is AFTER. AFTER2 and NONE can only be
selected when Cutter unit is installed.
3.
Press the FEED button to confirm your selection and proceed to the next
setting.
DR308e Operator's Manual
Section 3: Operation and Configuration
Page 3-17