SATO DR308e Operator's Manual page 51

3.11 DEFAULT SETTING MODE (cont'd)
3.11.1 Reset Printer Setting to Default Setting
Occasionally it is desirable to reset all printer configuration settings to their original default conditions. This
allows the operator to start reconfiguration of the printer starting from a know set of conditions.
1.
After pressing FEED button in DEFAULT MODE, press LINE button to
select PRINTER SETTING.
2.
Press FEED button to enter selection.
PRINTER YES NO is displayed.
3.
Press LINE button to select YES or NO.
4.
Press FEED button to enter the selection.
5.
If YES is selected, the printer will reset to the original default condi-
tions. SETTING COMPLETE is displayed with 3 beep sound.
If NO is selected, the printer will stop the process and CANCELED is
displayed.
To exit the Default Setting Mode, switch the POWER to Off and then On
again.
3.11.2 Reset the Alternate Protocol codes to the Default Values
The standard protocol codes used by the printer can be modified to accommodate the requirements of
different host systems. However, if the printer is to be used with a system that does not use the custom
protocol codes, they can be cleared and the default protocol codes reactivated.
1.
After pressing FEED button in DEFAULT MODE, press LINE button to
select ALT.PROTOCOL.
2.
Press FEED button to enter selection.
ALT.PROT YES NO is displayed.
3.
Press LINE button to select YES or NO.
4.
Press FEED button to enter the selection.
5.
If YES is selected, the printer will replace to the Alternate protocol
codes with the default values. SETTING COMPLETE is displayed with
3 beep sound.
If NO is selected, the printer will stop the process and CANCELED is
displayed.
To exit the Default Setting Mode, switch the POWER to Off and then On
again.
DR308e Operator's Manual
Section 3: Operation and Configuration
Page 3-27