SATO DR308e Operator's Manual page 12

Section 1: Introduction
1.2 PARTS IDENTIFICATION (cont'd)
Adjustment compartment at the right bottom side of DR308e
26 CHECK connector
27 DISP potentiometer
28 F-OFFSET potentiometer
29 J-HOLE potentiometer
30 IM potentiometer
15 26
CHECK connector
This is a connection terminal for sensor level
adjustment jig.This is only used by Sato
certified servicing personnel.
16 27 DISP potentiometer
To adjust the sensing level of the optional
dispenser.
17 28 F-OFFSET potentiometer
Factory offset adjustment. Adjust only when
instructed by Sato certified servicing
personnel.
18 29 J-HOLE potentiometer
Jump hole sensor adjustment.
IM potentiometer
19 30
I-mark sensor adjustment.
Page 1-6
20 31
PRINT potentiometer
To adjust the darkness of the printing.
21 32
OFFSET potentiometer
To adjust the option stop positions (cutter
position, dispensing position and tear-off
position).
22 33
PITCH potentiometer
To adjust the beginning print position.
23 34 DSW dip switch
To set the printer to different modes when
servicing. This is only used by Sato certified
servicing personnel.
24 35
GAP potentiometer
Gap sensor adjustment.
31 PRINT
potentiometer
32 OFFSET potentiometer
33 PITCH potentiometer
34 DSW dip switch
35 GAP potentiometer
DR308e Operator's Manual