Unpacking; Included Accessories - SATO DR308e Operator's Manual

Section 1: Introduction

1.1 UNPACKING

When unpacking the printer, take note of the following:
1. The box should stay right-side up.
Lift the printer out of the box carefully.
2. Remove all the packaging covering from the printer.
3. Remove the accessory items from their protective containers.
4. Set the printer on a solid, flat surface. Inspect the shipping container and printer for any sign of damage
that may have occurred during shipping.
Notes
• If the printer was been stored in the cold, allow it to reach room temperature before turning it on.
• Please do not discard the original packaging box and cushioning material after installing the printer. They
may be needed in future, if the printer needs to be shipped for repairs.

1.1.1 Included Accessories

After unpacking the printer, verify that the following materials are in the accessories or packaging:
User Documentations
(Quick Guide, Warranty, etc.)
Ferrite core (for attaching
to power cable)
* The shape of the power plug may varied depending on the location of purchased.
Page 1-2
Head cleaning sheet
Ribbon core (for winding)
Power cable*
Extension guide plates,
core adaptor, screw to
secure the core adaptor
DR308e Operator's Manual