SATO DR308e Operator's Manual page 78

Section 7: Interface Specifications
7.6 EXTERNAL SIGNAL INTERFACE (EXT) (cont'd)
7.6.1 Basic Specifications
Connector
Input/Output
circuit diagram
Signal level
Designation for issuing EXT
signal
External signal type
Reissuing EXT signal
Page 7-10
14-pin external signal interface
14-PIN type 14-PIN type
Input/Output connection example Input/Output connection example
Peripheral device Peripheral device
5-40V 5-40V
High level : +4.2~5V
Input terminal Iin≒0mA, Output terminal Iout≒0mA
Low level : 0~0.7V or under
Input terminal Iin≒10mA, Output terminal Iout≒10mA
Set "ENABLE/DISABLE" in the Advanced Mode
The following signal types are available in the Advanced Mode.
Type
Print end signal (PREND) is "Low" before printing labels. The signal
TYPE I
level is "High" after the completion of print and will be "Low" 20 ms
(T1)
later.
Print end signal (PREND) is "High" before printing labels. The signal
TYPE II
level is "Low" after the completion of print and will be "High" 20ms
(T2)
later.
Print end signal (PREND) is "Low" before printing labels. The signal
TYPE III
level is "High" from the start to the end of print and will be "Low" after
(T3)
the completion of print.
Print end signal (PREND) is "High" before printing labels. The signal
TYPE IV
level is "Low" from the start to the end of print and will be "High" after
(T4)
the completion of print.
The following settings are available in the Advanced Mode.
ENABLE: Reprinting the same data
DISABLE: No reprint
13 +5V 13 +5V
8 8
R R
L L
Iin Iin
Input Input
Output Output
Iout Iout
330Ω 330Ω
SG ground SG ground
2 2
FG(Frame Ground) FG(Frame Ground)
Action / Explanation
Printer Printer
JP7(Sel ects power suppl y for input) JP7(Sel ects power suppl y for input)
3 2 1 3 2 1
330Ω 330Ω
DR308e Operator's Manual