Capturing Text In More Than One File; Disconnect; Modify - Tandy 600 Owner's Manual

)
)
)
)
,
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
Capturing Text in More Than One File
If the text capture file reaches its maximum size before you capture all
incoming text, Telcom displays an error message and returns to the
Command mode. The message line shows:
Output file too large
Perform these steps to continue capturing the incoming information:
I. At the Session command menu, press
[QJ
for the Options command.
The Options command fields appear.
2. Type a new filename at the capture to field, and press I
ENTER
I.
Telcom closes (saves) the current text capture file and opens the new
file. Remaining incoming text goes into the new file.
3. Press
IT]
for Connect to return to the Terminal mode.
Disconnect
Use the Disconnect command to terminate the communications
connection, or "disconnect." Note that communication is
not
disconnected
until either you use this command or the computer has been left idle for the
amount of time specified in the disconnect after field of the Options
command.
At the Session command menu, press
[Q]
for Disconnect. The screen
shows:
Enter Y to confirm
Press
[Y]
to disconnect or []] to continue.
Modify
Use the Modify command to change the Telcom communication settings.
The values in the settings field of the phonebook file appear for each listed
name. You can modify the settings for each name, and/or for the default
field. The settings you use as the default will also be used when you use
Telcom without specifying a phonebook file.
155