Removing The Connecting Rods And Pistons - Yamaha FZS1000N Service Manual

Hide thumbs Also See for FZS1000N:

Table of Contents

REMOVING THE CONNECTING RODS AND

The following procedure applies to all of the

connecting rods and pistons.

connecting rod cap 1

big end bearings

Identify the position of each big end bearing so

that it can be reinstalled in its original place.

piston pin clips 1

piston pin 2

Do not use a hammer to drive the piston pin

For reference during installation, put identifica-

tion marks on the piston crown.

Before removing the piston pin, deburr the pis-

ton pin clip's groove and the piston's pin bore

area. If both areas are deburred and the piston

pin is still difficult to remove, remove it with the

piston pin puller 1 .

Piston pin puller

Chapters

Table of Contents