Yamaha FZS1000N Service Manual page 156

FRONT AND REAR BRAKES
3. Install:
S brake master cylinder 1
NOTE:
S Install the brake master cylinder holder with
the "UP" mark facing up.
S Align the end of the brake master cylinder hold-
er with the punch mark a on the handlebar.
S First, tighten the upper bolt, then the lower bolt.
4. Install:
S copper washers 1
S brake hose 2
S union bolt 3
a
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure that the
brake pipe touches the projection a on the
brake master cylinder.
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
"CABLE ROUTING".
NOTE:
S While holding the brake hose, tighten the
union bolt as shown.
S Turn the handlebar to the left and to the right to
make sure that the brake hose does not touch
other parts (e.g., wire harness, cables, leads).
Correct if necessary.
5. Fill:
S brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
4-31
CHAS
10 Nm (1.0 mSkg, 7.2 ftSlb)
New
30 Nm (3.0 mSkg, 22 ftSlb)
WARNING
Recommended brake fluid
DOT 4