Yamaha FZS1000N Service Manual page 57

Starter cable
1
Clutch cable
2
Handlebar switch lead (left)
3
Main switch lead
4
EXUP servo motor
5
Starting circuit cutoff relay
6
Starter motor lead
7
Fan motor relay
8
Air cleaner case drain hose
9
Sidestand switch lead
10
oil level switch lead
11
ACgenerator lead
12
Water-head pipe
13
Water-carburetor hose
14
Throttle cable 2
15
Throttle cable 1
16
EXUP cable
17
CABLE ROUTING
A Fasten the main switch lead and handlebar switch lead with a plastic
guide.
B Fasten the water-head hose and water-carburetor hose with a plastic
band.
C Fasten the clutch cable with a plastic band.
D Fasten the clutch cable with a steel clamp.
E Fasten the wire harness with a plastic band.
F To the fuel sender.
G Route the fuel sender lead inside the seat rail.
H Route the battery negative lead forward the frame stay.
I Route the main harness inside the rear fender groove.
J Fasten the wire harness, sidestand switch lead, oil level switch and
flame with a plastic band. Do not fasten the Acgenerator lead (white).
K Route the starter motor lead and battery negative lead inside the plastic
band.
L Route the all hoses outside the fuel hose.
M Route the fuel hose through the steel guide.
2-38
SPEC