Yamaha FZS1000N Service Manual page 58

N Fasten the sidestand switch lead, oil level switch lead,
ACgenerator lead, starter motor lead, battery negative
lead and air cleaner case drain hose with a plastic clamp.
O Fasten the sidestand switch lead, oil level switch lead,
ACgenerator lead and air filter case drain hose with a
plastic clamp.
P Fasten the sidestand switch lead and frame with a plastic
clamp.
Q Route the air cleaner box drain hose inside the sidestand
switch lead, and put the end of the hose backward.
R Fasten the sidestand switch lead and frame with a plastic
clamp.
S Fasten the sidestand switch lead, oil level switch lead and
air filter case drain hose with a plastic clamp. Do not crush
the air filter case drain hose.
T Route the high tension cable (#1) outside the starter cable
and water-carburetor hose, and under the clutch cable
CABLE ROUTING
and rectifier regulator lead.
U Route the water carburetor hose outside the coolant
hose.
V Route the starter cable outside the coolant hose, and up-
per the water-carburetor hose.
W Route the high tension cable (#2, 3) forward the EXUP
cable and high tension cable (#4).
X Route the throttle cable between the water-head hose,
and upper the EXUP cable.
Y Route the high tension cable (#4) between the water-
head hose.
Z Taillight lead and flasher light lead (right) should not be
stick out from the gap between the rear fender and tail-
light.
AA Route the flasher light lead through the hole on the rear
fender.
AB Route the wire harness in the groove.
2-39
SPEC