Yamaha FZS1000N Service Manual page 56

I Route the water-carburetor hose between the
frame cross pipe and fan motor lead.
J To the carburetor
K Fasten the T.P.S. lead with a steel clamp.
L Fasten the coolant hose with a plastic band.
M Fasten the pickup coil lead with a steel clamp.
N Pass the coolant reservoir tank overflow hose, fuel
tank drain hose and fuel tank breather hose through
the frame hose holder from the inside of the vehicle
to the outside. At this time, pull the fuel tank drain
hose and fuel tank breather hose so that the white
paint marks are within a 20 mm (0.79 in) range.
O Route the EXUP cable forward the another hoses,
and upward the engine mounting bracket.
P Fasten the rear brake light switch lead with a plastic
guide.
CABLE ROUTING
Q Insert the all couplers into the rubber cover.
R Route the rear brake light switch lead inside the
another leads.
S Route the neutral switch lead and speed sensor
lead left side the coolant reservoir hose.
T Route the coolant reservoir hose left side the en-
gine mounting bracket.
U Route the coolant reservoir hose forward the neu-
tral switch lead and speed sensor lead.
V Route the coolant reservoir hose backward the
another hoses.
W Route the EXUP cable forward the another hoses.
X Route the EXUP cable forward the frame cross
pipe.
Y Route the fuel tank drain hose and fuel tank breath-
er hose forward the neutral switch lead and speed
sensor lead.
2-37
SPEC