Configuring The Tunnel Edit Screen - ZyXEL Communications ZyWall USG 50-H Series User Manual

Chapter 8 Interface
Table 56 Network > Interface > Tunnel (continued)
LABEL
My Address
Remote Gateway
Address
Add icon
Apply
Reset

8.9.2 Configuring the Tunnel Edit Screen

This screen lets you configure a GRE tunnel interface. To access this screen, in the Network >
Interface > Tunnel screen click the Add icon at the top of the Add column or click an Edit
icon next to a tunnel interface. The following screen appears.
180
DESCRIPTION
This is the interface or IP address uses to identify itself to the remote gateway.
The ZyWALL uses this as the source for the packets it tunnels to the remote
gateway.
This is the IP address or domain name of the remote gateway to which this
interface tunnels traffic.
This column lets you create, edit, remove, activate, and deactivate interfaces.
To create a tunnel interface, click the Add icon at the top of the column. The
Tunnel Edit screen appears.
To activate or deactivate an interface, click the Active icon next to it. Make sure
you click Apply to save and apply the change.
To edit an interface, click the Edit icon next to it. The Tunnel Edit screen
appears.
To remove an interface, click the Remove icon next to it. The ZyWALL confirms
you want to remove it before doing so.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
ZyWALL USG 50-H User's Guide