Diffserv - ZyXEL Communications ZyWall USG 50-H Series User Manual

Policy Routes Versus Static Routes
• Policy routes are more flexible than static routes. You can select more criteria for the
traffic to match and can also use schedules, NAT, and bandwidth management.
• Policy routes are only used within the ZyWALL itself. Static routes can be propagated to
other routers using RIP or OSPF.
• Policy routes take priority over static routes. If you need to use a routing policy on the
ZyWALL and propagate it to other routers, you could configure a policy route and an
equivalent static route.

10.1.3 DiffServ

QoS is used to prioritize source-to-destination traffic flows. All packets in the same flow are
given the same priority. CoS (class of service) is a way of managing traffic in a network by
grouping similar types of traffic together and treating each type as a class. You can use CoS to
give different priorities to different packet types.
DiffServ (Differentiated Services) is a class of service (CoS) model that marks packets so that
they receive specific per-hop treatment at DiffServ-compliant network devices along the route
based on the application types and traffic flow. Packets are marked with DiffServ Code Points
(DSCPs) indicating the level of service desired. This allows the intermediary DiffServ-
compliant network devices to handle the packets differently depending on the code points
without the need to negotiate paths or remember state information for every flow. In addition,
applications do not have to request a particular service or give advanced notice of where the
traffic is going.
DSCP Marking and Per-Hop Behavior
DiffServ defines a new DS (Differentiated Services) field to replace the Type of Service
(TOS) field in the IP header. The DS field contains a 2-bit unused field and a 6-bit DSCP field
which can define up to 64 service levels. The following figure illustrates the DS field.
DSCP is backward compatible with the three precedence bits in the ToS octet so that non-
DiffServ compliant, ToS-enabled network device will not conflict with the DSCP mapping.
The DSCP value determines the forwarding behavior, the PHB (Per-Hop Behavior), that each
packet gets across the DiffServ network. Based on the marking rule, different kinds of traffic
can be marked for different kinds of forwarding. Resources can then be allocated according to
the DSCP values and the configured policies.
Finding Out More
• See Section 5.4.9 on page 85
• See Section 10.4 on page 234
• See Section 6.5.3 on page 112
VPN tunnel.
ZyWALL USG 50-H User's Guide
DSCP (6 bits)
for related information on the policy route screens.
for more background information on policy routing.
for an example of configuring a policy route for an IPSec
Chapter 10 Policy and Static Routes
Unused (2 bits)
227